 |
|
2. Common Problems
- Q: I get the message ioctl(SIOCGIFBR) failed: Package not installed . What does this mean?
- Q: Machines on one side cannot ping the other side!
- Q: I cannot telnet/ftp from the bridge! Why?
- Q: What do I need to set up in the way of routing?
- Q: The bridge appears to work, but why doesn't traceroute show the bridge as a part of the path?
- Q: Is it necessary to compile IP_FORWARD into the kernel?
- Q: Why are the physical ethernet addresses for port 1 and port 2 the same according to the brcfg program? Shouldn't they be different?
- Q: Bridging does not appear to be an option when performing a make config on the kernel. How does one enable it?
- Q: Too many hubs (4 or more) are chained one after another in series, cause timing problems on an ethernet. What effect does a bridge have in a subnet that is layered with hubs?
- Q: Can a bridge interface to both 10Mb and 100Mb ethernet segments? Will such a configuration slow down the rest of the traffic on the high speed side?
A: You don't have bridging capability in your kernel. Get a 2.0 or greater kernel, and recompile with the BRIDGING option enabled.
A:
A: This is because there is no IP address bound to any of bridge interfaces. A bridge is to be a transparent part of a network.
A: Nothing! All routing intelligence is handled by the bridging code in the kernel. To see the ethernet addresses as they are learned by the bridge, use the brcfg program in debug mode:
brcfg -deb
|
A: Due to the nature of a bridge, a traceroute should NOT show the bridge as a part of the path. A bridge is to be a transparent component of the network.
A: No. The bridging code in the kernel takes care of the packet transport. IP_FORWARD is for a gateway that has IP addresses bound to its interfaces.
A: No. Every port on a bridge intentionally is assigned the same physical ethernet address by the bridging code.
A: During the kernel config, answer "Y" to the question, Prompt for development and/or incomplete code/drivers (CONFIG_EXPERIMENTAL) [Y/n/?].
A: A bridge resets the 3/4/5 hubs rule. A bridge does not deal with packets the way a hub does, and is therefore not a contributor to timing problems on a network.
A: Yes, a bridge can tie together a 10Mb segment with a 100Mb segment. As long as the network card on the fast network is 100Mb capable, TCP takes care of the rest. While it's true that the packets from a host in the 100Mb network communicating to a host in the 10Mb network are moving at only 10Mb/s, the rest of the traffic on the fast ethernet is not slowed down.
Hosting by: Hurra Communications Ltd.
Generated: 2007-01-26 17:58:16